Tenergy LiFePO4 RCR123A Smart Battery Charger
with 2 RCR123A LI-ON 3.0V Batteries
$29.95
Order Now
Cleans the air in your
personal breathing space. Great for anyone forced to breath the same recycled air
in confined spaces.
Use this handy battery
charger to bring new life to your thirsty RCR123A
rechargeable batteries and use you camera, Wein Personal
Air filter continuously. This is the most economical way
to operate your devices that require a 3.0V lithium
battery, and Tenergy is the best way to go.
Battery Charger Features
-
Worldwide usage. Auto AC power adjust from 100-240V.
-
Smart, build-in microprocessor automatically switch off when batteries are fully charged.
-
Safe, build-in IC provides various protection, thermal protection, overcharge protection, short-circuit protection, mechanical and electrical protection against reversal polarity, and auto defective battery identification.
-
Convenient, 12V car cigarette lighter plug for on
the road charging.
-
Compact ( 2.5 x 4 x 1 inch ), Light weight ( 5 oz only ), include charger and all accessories.
-
Fast Charge 1 to 2 RCR123A from 1.5 hours to 3
hours. Peak voltage of 3.0V Li-Ion will be 3.60V
after fully charged. This charger is only compatible with RCR123A 750mAh
batteries. This charger is not compatible with
900mAh RCR123A Batteries.
New Chemical LiFePO4 Li-Ion battery
-
Rechargeable LiFePO4 RCR123A 3.0V 750mAhBattery
-
Life cycle: 2000 times (Traditional Li-ion: 500 times)
-
Never explode or catch fire
-
100% Compatible with Disposable CR123A Batteries
-
Working Voltage:3.2V and Peak Voltage: 3.6V
-
Charging cut-off voltage: 3.6V
-
Discharge cut-off voltage: 2.2V
-
Please never overdischarge battery below 2.2V/cell
-
Charge the this battery with LiFePO4 RCR123A smart charger
-
Capacity: Nominal: 450mAh
- Maximum:750 mAh
-
Maximum discharging rate:< 550 mA
-
Maximum charge current: <550 mA
-
Cell's dimension: 17mm Dia. x 34.5mm H.
-
Weight: 0.6 oz (18 grams).
-
NOT COMPATIBLE WITH SUREFIRE FLASHLIGHT. DON'T USE
THESE BATTERIES WITH ANY SURE FIRE FLASHLIGHTS.
Important Notes
-
It is
normal that new battery can not be charged to its
rated capacity when it is being used for the first
time. To reach full capacity, new batteries have to
be charged and discharged 3 to 5 cycles.
-
Batteries will self-discharge when not in use.It is
recommended that you do not let battery sit idle for
a long time without use.
Operating Instructions:
-
Insert the batteries into the battery compartments
with correct directions of polarity.
-
Connect the adapter to the charger and switch on the
power.
-
Green
LED indicates the power is on if, there is no
battery in the battery compartment.
-
Red
LED indicates the batteries are charging properly.
When Red LED turns to Green, the batteries are fully
charged.
Caution:
-
This
charger is intended for use with 3.0V RCR123A
LiFePO4 batteries only. Attempts to charge other
types of batteries might cause personal injury and
product damage.
-
Indoor use only. Do not expose the charger to rain
or moisture
-
Operating temprature. 0C~35 C
-
Before use read instructions.
-
NOT
responsible for any damage or injury caused by
misuse or not following the instruction or not
paying attention to the warning or caution listed
here.
Tenergy LiFePO4 RCR123A Smart Battery Charger |
Read Delayed Shipping Notice |
Tenergy LiFePO4 RCR123A Smart Battery Charger - with 2 RCRA123A Rechargeable batteries |
$29.95 |
|
Extra Rechargeable
Tenergy RCR123A Lithium Battery |
$3.00 |
|
Shipping is FREE
in the USA for orders over $100.00
|
All Air Filtration Products
Product Categories:
Far Infrared |
Exercise
|
Sleep Aid
| Water
Filtration
|
Air Filtration
| Test Kits
|
Supplements
|
Health
Books
| EMF
Protection |
Juicers
|
Skin Care
|
Emergency Products
Internet
Partners
Home |
Privacy Policy |
Return
Policy |
Disclaimer
|
Contact Us
Copyright 2011-2013, MicroWaterWoman.com, All Rights Reserved
|